VOGUE/ELITE/DOUBLE TRAK
-
Measure and mark where you want each bracket to be placed, spacing them
approximately one metre apart. Fix brackets firmly to the wall, allowing
enough room for finial (Vogue only).
-
For double track, press the Minitrak horizontally onto the back clip.
-
Attach finials to track. Clip the top part of the Colourtrak onto each bracket.
To obtain the right position, slide track sideways to line up evenly over
the window.
-
Roll the Colourtrak (from the centre point of the rod) in a downward motion
and click firmly into place.
MINITRAK
-
Measure and mark where you want the brackets to be placed, spacing them
approximately one metre apart. Fix brackets firmly to wall.
-
Place the Minitrak directly over the attachment area of the bracket. To obtain
the right position, slide the track sideways and line up evenly over the
window.
-
Press the Minitrak into each bracket until it clips into place. (NB. There
should be an audible click when the Minitrak is attached correctly).
COVETRAK
-
Measure and mark where you want the fixing holes to be placed on the Covetrak.
-
Drill fixing holes into Covetrak.
-
Screw into place above window or pot rivet into aluminum joinery.
COMPACTRAK
Screw directly into the underside of the window frame or where desired.
BORDEAUX ROD
-
Loosely fit end bracket to wall, using only two of the four screws.
-
Thread rings or tab curtains and attach centre bracket to wall (if applicable)
-
Thread the rest of rings or tabs for opposite side and attach opposite end
bracket, again using only two of the four screws.
-
When rod is in place, use the remaining screws and tighten brackets.
 BENDS
-
Fix brackets to longest wall.
-
Clip all other brackets directly to the track at fixed positions before fitting
to wall.
-
Place Colourtrak on the brackets fitted to the longest wall. Roll downwards
and click into place. BE CAREFUL NOT TO DAMAGE SURROUNDING WALLS WITH
BRACKETS ALREADY ATTACHED!!!!
-
Screw each outside bracket to the wall, then any not yet fixed. (IF IN DOUBT
CLIP ALL BRACKETS TO TRACK, THEN FIX)
HOLDBACKS
-
Put Holdback in "down" position (ensure the Holdback is straight).
-
Mark drill holes through the base and put in toggles, if required.
-
Screw Holdback in place.
-
Move Holdback into "up" position and use!
|
